Order Form

Click here to view brochure and order form. To place an order, print the order form and FAX to our office at 707-864-3395.

Click here to see available designer colors.

HOW TO ORDER A BE-LITE ALUMINUM SPA COVER
(All measurements should be in inches)
(For more detailed measuring instructions, go here)

 

Good Method:

Give us the spa size outside dimensions (of lip) and inside dimensions of (water line) and we will make the cover one (1) inch smaller than the outside dimension, so that the cover will rest on the lip of the spa. This will be one-half (1/2) inch on each side. Please note on your order form any controls, speakers etc. that are above the lip of the spa.

Best Method:

Make a template of the spa.

1. Purchase a clear plastic painters drop cloth from a hardware or paint store (thicker is easier to work with), must be at least 5 mil thick or it will stretch.

2. Stretch plastic over spa and pull tight, so there are no wrinkles or bubbles and secure to side of spa using tape.

3. With a felt maker:

a) Mark plastic “this side up”

b) Trace outside (O.D.) of shell on all sides.

c) Trace inside (I.D.) of shell on all sides. If the spa is built in, indicate this as waterline.

d) Trace an outline of controls and anything on top of spa lip that might hinder a good seal.

e) Keeping in mind that the seal must rest on a flat surface to seal correctly, mark where you would like the cover to rest with a dotted line. If you are not sure, skip this step and we will determine it for you.

f) With a dotted line, mark where you would like the hinge. If no markings, then we will determine the best location.


Our covers are made from aluminum and foam. The cover is a full 2” thick for added insulating value and is protected by our limited warranty. The top and bottom surfaces are silver aluminum with a baked on enamel painted finish. The outer edge is anodized for longer lasting beauty. Each spa cover is custom made to fit your spa and your needs.

About Us

Our Aluminum Spa Covers have been covering spas and keeping children and pets safe for over 35 years. We use superior materials and hand make each cover. These customized covers are not a one and done cover, but will last for many years. Our Aluminum Spa Covers can hold up to 800 lbs; snow loads are no problem, they will support weight and won’t buckle in the middle. Make this the last spa cover you ever buy. Designer options/colors available. Call one of our customer service representatives today, we are here to answer your questions.

Contact Us

4925 Fulton Drive Fairfield,CA 94534

(707) 864-8919

belite@poolcoversinc.com